Welcome Guest ( Log In | Register )

Dither after adding four PCM 16 bit signals?
post Oct 16 2012, 21:59
Post #1

Group: Members
Posts: 2
Joined: 16-October 12
Member No.: 103896

Hello all!

My DSP application is implemented on a FPGA using VHDL. Basically there are four 16-Bit PCM audio signals with 48k sample rate.
After processing each audio signal separately (one multiplication with a factor that depends on a sensor) i add those four audio signals to get a unified signal.
So the question is now, when i add those four audio signals i get a 18 bit result, but i must reduce the bit depth back to 16 bit to hand it to the audio codec chip (DAC).
Should i dither in this case? Or what is the typical approach when adding PCM audio signals and then want to go back to the original bit depth?
All calculation is done in fixed point.


This post has been edited by Zopfi: Oct 16 2012, 22:00
Go to the top of the page
+Quote Post
Start new topic
post Oct 17 2012, 19:43
Post #2

Group: Members
Posts: 3623
Joined: 1-September 05
From: SE Pennsylvania
Member No.: 24233

If you are carrying out calculations to a higher precision than the target bit depth then only dither as part of the final stage of bit depth reduction.
Go to the top of the page
+Quote Post

Posts in this topic

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:


RSS Lo-Fi Version Time is now: 9th October 2015 - 10:07