Welcome Guest ( Log In | Register )

Reply to this topicStart new topic
what's the meaning of "lookahead"?
post May 6 2006, 15:58
Post #1

Group: Members
Posts: 1
Joined: 28-April 06
Member No.: 30138

This post has been edited by xjf: May 7 2006, 02:24
Go to the top of the page
+Quote Post
post May 6 2006, 19:33
Post #2

Group: Members (Donating)
Posts: 815
Joined: 12-September 03
Member No.: 8821

Ugh, what do you mean? Where do you see that? Why are you asking in Speech Codecs forum?
The only tip that one can give you for such a vague question is that "lookahead" = "look ahead" (looking at something that is incoming). Perhaps Wikipedia definition has a good answer for your badly stated question.
Go to the top of the page
+Quote Post
Kees de Visser
post May 6 2006, 23:10
Post #3

Group: Members
Posts: 760
Joined: 22-May 05
From: France
Member No.: 22220

I don't know of a specific meaning in the context of Speech Codecs.
AFAIK in general audio it means "looking or listening to a signal before it's actually needed". This will give you some extra time to decide what to do with it.
Example: in the old days of LP vinyl cutting, the analog mastertape was played back on a special recorder with 2 playback heads. The first head was used by the mastering engineer to listen to the tape (and see the peak level on a meter) and make small corrections if needed. The second head was used to feed the cutter. There was a delay of (IIRC) a few seconds between them (depending on the tape speed) so the engineer had some time to react (usually to reduce level peaks to prevent distortion).

Hope that answers your question.
Go to the top of the page
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:


RSS Lo-Fi Version Time is now: 29th November 2015 - 05:54