Welcome Guest ( Log In | Register )

Reply to this topicStart new topic
stereo to 5.1 in software?, Can I convert stereo to 5.1 in software?
post Jan 25 2004, 00:29
Post #1

Group: Members
Posts: 1
Joined: 23-January 04
Member No.: 11468

Our planetarium has just converted from stereo to 5.1 channel sound. All of our existing shows have stereo soundtracks, which only take advantage of a small portion of our new sound system.

We are looking for some way to convert our existing stereo soundtracks into 5.1 using software.

To test the concept using hardware, we temporarily connected an NAD home theater amp and used it to decode the audio using Dolby Prologic. The Dolby decoder was able to create 5.1 audio that was quite impressive. Unfortunately, this will not work as a permanent solution, because we need all 6 channels stored seperately on our hard drive as wav files. (This is a requirement built into the planetarium)

We have considered purchasing an 8 channel digitizer to capture the audio output of the NAD amp and store it as 6 discrete channels, but this is expensive, awkward, and requires that our audio go from digital to analog to digital several times.

We are hoping there is a software decoder that will take a stereo sound file as input and produce 6 seperate files as output.

We would also consider any other reasonable solutions.
Go to the top of the page
+Quote Post
post Jan 25 2004, 10:23
Post #2

A/V Moderator

Group: Members
Posts: 858
Joined: 12-May 03
From: Finland
Member No.: 6557

There is a nice guide on stereo to multichannel conversion at Doom9's forum. It is based on the Ambisonics method. I don't know how it works for other sources but it's worth the try if it could save money.
Go to the top of the page
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:


RSS Lo-Fi Version Time is now: 28th November 2015 - 08:27