IPB

Welcome Guest ( Log In | Register )

Overread Lead In Only, HL-DT-ST CD-RW GCE-8240B
prbatman
post Jan 19 2004, 17:16
Post #1





Group: Members
Posts: 44
Joined: 21-October 03
Member No.: 9410



Hi,

My above drive only reads into Lead In.

It has an offset of +733 and the drive is set at this.

As it only reads into Lead In I have not ticked the box Reads Into Lead In/Lead Out.As I've read it will cause a read error at the end of the disc.

Is this set up correct.Do you only tick Reads into Lead In/Out if the drive does both?

Thanks,

Ian cool.gif
Go to the top of the page
+Quote Post
 
Start new topic
Replies
magic75
post Jan 22 2004, 09:59
Post #2





Group: Members
Posts: 511
Joined: 2-December 02
Member No.: 3959



QUOTE (ScorLibran @ Jan 21 2004, 11:19 AM)
So, I'd recommend not turning on "Read Into Lead-In/Lead-Out" if your drive only reports reading into Lead-In.

Ah, the problem you have heard of can occur when the box is ticked and
a) offset correction is positive and drive only reads lead-in
b) offset correction is negative and drive only reads lead-out

Check the thread i referred to in my previous post, Pio2000 has a good explanation.

So if your drive has a negative offset correction value and only reads into lead-in it is safe to tick the box, since a negative value would mean that EAC only would attempt to read lead-in (not lead-out). But since your drive has a positive correction value it is of course absolutely correct not to tick the box...

This post has been edited by magic75: Jan 22 2004, 10:01
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



RSS Lo-Fi Version Time is now: 18th December 2014 - 22:24