IPB

Welcome Guest ( Log In | Register )

Help with headphone compatibility
MagR
post Apr 14 2013, 10:28
Post #1





Group: Members
Posts: 14
Joined: 17-March 13
Member No.: 107264



Hi

Iíve ordered an O2 amp with ODAC which I should get in a couple of weeks. This is the open source amp and DAC by NWAVGuy who recommends this forum for objective advice.

I already own Sennheiser HD650ís which this amp will have no problem driving looking at the specs and reading user reports. I want to know your thoughts on this ampís abilities to drive two other headphones I am interested in to experience their different sound signatures.

Firstly the AKG K701 Ė I keep reading this headphone is hard to drive but the specs Iíve found donít seem to bear this out. The impedance is 62 ohms which is quite low compared to the HD650 at 300ohms. The sensitivity is 105 db per volt which is similar to the HD650ís 103db per volt and equates to about 97db per milliwatt. I donít understand why people are saying the AKGís are more diicult to drive than the Sennheisers as these specs suggest it should be the other way round. Has anyone got any experience with this headphone and the O2 amp?

The second headphone I am interested in is the Beyerdynamic DT880 600ohm. NWAVGuy says this needs at least 5 volts to drive and the O2 can put a maximum of 7 volts into 600ohms. It looks like this is ample to handle this headphone on paper but I want to know if anyone has any experience of actually using this combination rather than relying on hearsay. What I donít want is to regularly run the amp right up to its limits in case it gets a bit ragged. The music (and games in particular) I own vary quite considerably in volume hence amp requirements. Can anyone with experience confirm whether this amp has enough power for this amp in practical use?

My final question relates to the Beyerdynamic DT880 above. Iím drawn to the 600ohm version as the reports Iíve read suggest this sounds the best and has the best treble. There is also a 250ohm version (the original impedance I think) which is much easier to drive. Does anyone have any direct experience of the actual sonic difference between the 250ohm and 600ohm versions? If it is marginal then the 250ohm seems a safer bet as the O2 should handle this more easily.

Thanks in advance

Mag
Go to the top of the page
+Quote Post
 
Start new topic
Replies
pdq
post Apr 17 2013, 16:05
Post #2





Group: Members
Posts: 3377
Joined: 1-September 05
From: SE Pennsylvania
Member No.: 24233



Both are measures of efficiency/sensitivity, and their values are related by the impedance.
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



RSS Lo-Fi Version Time is now: 1st August 2014 - 05:09